This kit contain solar cells and a motor for experimentation with solar power. It has the components to make a fan and coloured spinner disk.

This set comes with a large solar panel, motor and fan, and a music module. The components are matched so that it is possible to make the music module play a simple tune or the motor run even when the sun is not fully out. The solar panel can also be used to power the solar gearbox. Solar panel measures 122 x 122 x 4mm and gives 2V and 550mA max.

This 190-piece set includes 3 sized chain gears, short frame, long drive axle, motor axle, red gear, chain, solar power pack and guide. The solar buggy can be driven using a 60W bulb within a 25cm distance or through sun exposure. A gearing down driving system is used to reduce the rotating speed of the driven gears and results in the increase in the driven power. The buggy carries a load of 500g.

Size: 185 x 140 x 55mm.

Solar cells encapsulated in polycarbonate case with a honeycomb of lenses on the surface to intensify and focus the power of the light onto the solar crystals below. The output current is 400mA. These cells are able to power solar motors when set below a 100W bulb. At the rear of the cells are metal fixing screws with hexagonal nuts for easy connection.

The power output of these cells may vary.

Size: 74 x 45 x 6mm

Solar cells encapsulated in polycarbonate case with a honeycomb of lenses on the surface to intensify and focus the power of the light onto the solar crystals below. The output current is 800mA. These cells are able to power solar motors when set below a 100W bulb. At the rear of the cells are metal fixing screws with hexagonal nuts for easy connection.

The power output of these cells may vary.

Size: 95 x 65 x 6mm